Linux version 2.4.5-acpi (root@libra) (gcc version 2.95.3 20010315 (release)) #1 2001年 6月29日 (金) 16:09:38 JST
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000e0000 - 00000000000eee00 (reserved)
 BIOS-e820: 00000000000eee00 - 00000000000ef000 (ACPI NVS)
 BIOS-e820: 00000000000ef000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000006fec000 (usable)
 BIOS-e820: 0000000006fec000 - 0000000006ff0000 (reserved)
 BIOS-e820: 0000000006ff0000 - 0000000007000000 (ACPI data)
 BIOS-e820: 0000000007000000 - 0000000007100000 (reserved)
 BIOS-e820: 00000000ffe00000 - 0000000100000000 (reserved)
Scan SMP from c0000000 for 1024 bytes.
Scan SMP from c009fc00 for 1024 bytes.
Scan SMP from c00f0000 for 65536 bytes.
Scan SMP from c009fc00 for 4096 bytes.
On node 0 totalpages: 28652
zone(0): 4096 pages.
zone(1): 24556 pages.
zone(2): 0 pages.
mapped APIC to ffffe000 (011dd000)
Kernel command line: BOOT_IMAGE=linux ro root=302
Initializing CPU#0
Detected 597.642 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1179.64 BogoMIPS
Memory: 110288k/114608k available (1147k kernel code, 3932k reserved, 413k data, 200k init, 0k highmem)
Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes)
Inode-cache hash table entries: 8192 (order: 4, 65536 bytes)
Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes)
Page-cache hash table entries: 32768 (order: 5, 131072 bytes)
CPU: Before vendor init, caps: 0080893f 0081813f 0000000e, vendor = 7
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (32 bytes/line)
CPU: L2 Cache: 512K (128 bytes/line)
CPU: Processor revision 1.3.1.3, 600 MHz
CPU: Code Morphing Software revision 4.2.3-8-103
CPU: 20010308 14:40 official release 4.2.3#1
CPU: After vendor init, caps: 0080893f 0081813f 0000000e 00000000
CPU:     After generic, caps: 0080893f 0081813f 0000000e 00000000
CPU:             Common caps: 0080893f 0081813f 0000000e 00000000
CPU: Transmeta(tm) Crusoe(tm) Processor TM5600 stepping 03
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: none
PCI: PCI BIOS revision 2.10 entry at 0xfcd4a, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
  got res[1000:10ff] for resource 0 of PCI device 10b9:5451 (Acer Laboratories Inc. [ALi])
  got res[10000000:10000fff] for resource 1 of PCI device 10b9:5451 (Acer Laboratories Inc. [ALi])
  got res[10001000:100017ff] for resource 0 of PCI device 104c:8020 (Texas Instruments)
  got res[10004000:10007fff] for resource 1 of PCI device 104c:8020 (Texas Instruments)
  got res[10002000:10002fff] for resource 0 of Toshiba America Info Systems ToPIC95 PCI to Cardbus Bridge with ZV Support
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Starting kswapd v1.8
VFS: Diskquotas version dquot_6.4.0 initialized
pty: 256 Unix98 ptys configured
Serial driver version 5.05a (2001-03-20) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
Real Time Clock Driver v1.10d
block: queued sectors max/low 73210kB/24403kB, 256 slots per queue
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ALI15X3: IDE controller on PCI bus 00 dev 80
PCI: No IRQ known for interrupt pin A of device 00:10.0. Please try using pci=biosirq.
ALI15X3: chipset revision 195
ALI15X3: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xefe0-0xefe7, BIOS settings: hda:DMA, hdb:pio
ALI15X3: simplex device:  DMA disabled
ide1: ALI15X3 Bus-Master DMA disabled (BIOS)
hda: TOSHIBA MK1016GAP, ATA DISK drive
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: 19640880 sectors (10056 MB), CHS=1222/255/63, UDMA(33)
Partition check:
 hda: hda1 hda2 hda3
floppy0: no floppy controllers found
ACPI: Core Subsystem version [20010615]
ACPI: Subsystem enabled
Power Resource: found
Power Resource: found
Power Resource: found
ACPI: System firmware supports S0 S3 S4 S5
Processor[0]: C0 C1 C2, throttling states: 8
Battery: socket found, battery present
AC Adapter: found
Power Button: found
Lid Switch: found
Thermal Zone: found
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 8192 bind 8192)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 200k freed
Linux PCMCIA Card Services 3.1.26
  kernel build: 2.4.5-acpi #1 2001年 6月29日 (金) 16:09:38 JST
  options:  [pci] [cardbus] [apm] [pnp]
Intel PCIC probe: PCI: Enabling device 00:12.0 (0000 -> 0002)
PCI: No IRQ known for interrupt pin A of device 00:12.0. Please try using pci=biosirq.

  Toshiba ToPIC100 rev 31 PCI-to-CardBus at slot 00:12, mem 0x10002000
    host opts [0]: [slot 0xe0] [ccr 0x17] [cdr 0x86] [rcr 0xc000000] [no pci irq] [lat 64/176] [bus 1/1]
    ISA irqs (default) = 3,4,5,7,12,15 polling interval = 1000 ms