Linux version 2.2.19 (root@libra) (gcc version 2.95.3 20010315 (release)) #1 Mon Jul 9 12:08:56 JST 2001
BIOS-provided physical RAM map:
 BIOS-e820: 0009f000 @ 00000000 (usable)
 BIOS-e820: 06eec000 @ 00100000 (usable)
Detected 597639 kHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1189.47 BogoMIPS
Memory: 111912k/114608k available (876k kernel code, 412k reserved, 1348k data, 60k init)
Dentry hash table entries: 16384 (order 5, 128k)
Buffer cache hash table entries: 131072 (order 7, 512k)
Page cache hash table entries: 32768 (order 5, 128k)
CPU: L1 I Cache: 64K  L1 D Cache: 64K
CPU: L2 Cache: 512K
CPU: Processor revision 1.3.1.3, 600 MHz [longrun]
CPU: Code Morphing Software revision 4.2.3-8-103
CPU: 20010308 14:40 official release 4.2.3#1
CPU: Transmeta(tm) Crusoe(tm) Processor TM5600 stepping 03
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xfcd4a
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Assigning I/O space 5800-58ff to device 00:30
PCI: Enabling I/O for device 00:30
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
TCP: Hash tables configured (ehash 131072 bhash 65536)
Starting kswapd v 1.5 
Detected PS/2 Mouse Port.
Serial driver version 4.27 with no serial options enabled
pty: 256 Unix98 ptys configured
Real Time Clock Driver v1.09
ALI15X3: IDE controller on PCI bus 00 dev 80
ALI15X3: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xefe0-0xefe7, BIOS settings: hda:DMA, hdb:pio

************************************
*    ALi IDE driver (1.0 beta3)    *
*       Chip Revision is C3        *
*  Maximum capability is - UDMA 66 *
************************************

ALI15X3: simplex device:  DMA disabled
ide1: ALI15X3 Bus-Master DMA disabled (BIOS)
hda: TOSHIBA MK1016GAP, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
 ALI15X3: Ultra DMA enabled
hda: TOSHIBA MK1016GAP, 9590MB w/0kB Cache, CHS=1222/255/63, (U)DMA
Partition check:
 hda: hda1 hda2 hda3
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 60k freed
Linux PCMCIA Card Services 3.1.27
  kernel build: 2.2.19 #1 Mon Jul 9 12:08:56 JST 2001
  options:  [pci] [cardbus] [pnp]
No PCI interrupt routing table!
Intel PCIC probe: 
  Toshiba ToPIC100 rev 31 PCI-to-CardBus at slot 00:12, mem 0x68000000
    host opts [0]: [slot 0xe0] [ccr 0x17] [cdr 0x86] [rcr 0xc000000] [no pci irq] [lat 64/176] [bus 1/1]
    ISA irqs (default) = 3,4,5,7,9,12,15 polling interval = 1000 ms